bally 873 slot machine reels keep spinning

You should not be able to twist the fork with your hand. If the handle stick down when the stop bracket is properly positioned, either other adjustments on the right side of the mech are needed or the fork on the handle is worn/loose. If you grab the clock fan to stop the mechanism from winding down after the kick the reels should spin freely. nudge the stop bracket forward until the reel wiper arms latch.

If reels 2 and 3 basically just jerk at the kick, easiest thing is operate the reel mech outside the machine to make sure the reels spin ok. the things the bars running from front to back under the reels are pivoting. Latch pawls are bally 2400 manual page 97 part #25. The bracket too far forward is the usual reason for the handle sticking down before the reels kick.Ģ] the reel latch pawls are still sticky and not rotating into position. If you push the reel wiper arm back and spin the reel with your finger and it's fine, then the usual two reasons for reels not spinning are:ġ] the L-shaped stop bracket is now too far back so the reel latch pawls aren't engaging before the reels kick. It takes hours to completely disassemble and clean individual pieces of a reel mech. Quote from: wolftalk on June 18, 2023, 05:30:43 PM I guess it depends on how bad it is and how much time you are willing to put into it.

You should clean off the reel wiper boards and payout counter disc with isopropyl alcohol and a scrub pad to remove any black crud. You shouldn't need to remove the index discs. If you take the reels off the shaft, don't remove the slotted metal index disc from the reel unless you carefully mark how to put it back on. Tri-flow or a light oil works fine in those. The reel themselves run on needle bearings. It tends to soften/displace old grease so just squirting that in and exercising the moving parts can free things up. Some lubricants like tri-flow can also be used.

Try not to force the old grease into places it's not already, so clean off the surface stuff before squirting into cracks. If going this route, remove the reels first and avoid spraying the coils. The see-if-it-works approach is use a spray solvent like brake cleaner (ideally a plastic safe one) and try and wash off/out as much of the old crud as possible. I guess it depends on how bad it is and how much time you are willing to put into it.

Bally 873 slot machine reels keep spinning